|
公司基本資料信息
|
mso-hansi-font-family:"Times New Roman"">一、電動砂當量測定儀產品簡介:
mso-hansi-font-family:"Times New Roman"">砂當量測定儀,本儀器交通部JTJ058 "Times New Roman"">-2000中(T0334 mso-hansi-font-family:"Times New Roman"">-1994 "Times New Roman"">)細集料砂當量試驗規程標準,適用于瀝青混合料及水泥混凝土,用天然砂、人工砂、石屑,其集料最大粒徑不超過4.75mm mso-hansi-font-family:"Times New Roman"">(圓孔篩5mm "Times New Roman"">),測定細集料中所含的粘性土或雜質的含量,以評定集料的潔凈程度。
mso-hansi-font-family:"Times New Roman"">二、電動砂當量測定儀技術參數:
1、額定電壓:220V mso-hansi-font-family:"Times New Roman"">±10 "Times New Roman"">%、~180W
2、額定功率:90W
3、震蕩頻率:180 mso-hansi-font-family:"Times New Roman"">次/min "Times New Roman"">±2次/min mso-hansi-font-family:"Times New Roman"">(運動周期)
4、試筒振幅:203mm mso-hansi-font-family:"Times New Roman"">±10mm
5、配重活塞:1kg mso-hansi-font-family:"Times New Roman"">±5g
6、外形尺寸:700 mso-hansi-font-family:"Times New Roman"">×420 "Times New Roman"">×510mm
7、塑料試筒:內徑32 mso-hansi-font-family:"Times New Roman"">±0.25mm "Times New Roman"">、高度420±0.25mm
8、沖洗管:外徑6 mso-hansi-font-family:"Times New Roman"">±0.5mm "Times New Roman"">、內徑4±0.2mm
9、總重:45 mso-hansi-font-family:"Times New Roman"">±1kg
10、環境溫度:≦35 mso-hansi-font-family:"Times New Roman"">℃
11、相對濕度:≦85%
mso-hansi-font-family:"Times New Roman"">三、電動砂當量測定儀操作與使用:
mso-hansi-font-family:"Times New Roman"">為了不影響沉淀的過程,試驗必須在無擾動的水平臺上進行。隨時檢查試驗的沖洗管口,防止堵塞。試驗過程中,沖洗液的溫度應保持20 mso-hansi-font-family:"Times New Roman"">±2 "Times New Roman"">℃范圍內。由于塑料在太陽下容易變成不透明,應盡量避免將塑料器皿直接暴露在太陽下。盛試驗溶液的塑料器皿用畢要清洗干凈。
1、用沖洗管將沖洗液吸入試筒直到100mm mso-hansi-font-family:"Times New Roman"">刻度(約80 "Times New Roman"">毫升)。
2、把相當于120 mso-hansi-font-family:"Times New Roman"">±1g "Times New Roman"">干料重的濕樣用漏斗倒入豎立試筒中。
3、反復敲打試筒下部,以除去氣泡使試樣濕潤,靜置10min mso-hansi-font-family:"Times New Roman"">。
4、試樣靜置10 mso-hansi-font-family:"Times New Roman"">±1min "Times New Roman"">結束后,用橡膠塞堵住試筒,將試筒水平固定在振蕩器上。(注意試筒底部方頭碰螺絲。)
5、開動振蕩器,在30 mso-hansi-font-family:"Times New Roman"">±1S "Times New Roman"">的時間內振蕩90 "Times New Roman"">次。用人工振蕩時,要用手將試筒橫向水平放置,僅需手腕振蕩,不必晃動手臂,振幅為203 mso-hansi-font-family:"Times New Roman"">±25mm "Times New Roman"">,振蕩時間和次數與振蕩器相同。然后將試筒取下,豎直放回試驗臺上,擰下橡膠塞。
6、將沖洗管插入試筒中,用沖洗液迅速?zèng)_洗附在試筒壁上的集料,然后將沖洗管插到試筒底部,慢慢轉動沖洗管,同時勻速緩慢提高沖洗管,使附著在集料表面的細粒雜質浮上來,直至溶液達到380mm mso-hansi-font-family:"Times New Roman"">刻度線為止。
7、緩慢勻速向想拔出沖洗管,當液面位于380mm mso-hansi-font-family:"Times New Roman"">刻度線時,切斷沖洗管的液流,使液面保持380mm mso-hansi-font-family:"Times New Roman"">刻度線,然后在沒有擾動的情況下靜置20min mso-hansi-font-family:"Times New Roman"">±15S
mso-hansi-font-family:"Times New Roman"">四、電動砂當量測定儀實驗步驟:
1、用沖洗管將洗液吸入試筒,直到最下邊的l00mm mso-hansi-font-family:"Times New Roman"">刻度處(約需80ML "Times New Roman"">沖洗液)。
2、把相當120 mso-hansi-font-family:"Times New Roman"">±1g "Times New Roman"">干料重的濕樣用漏斗仔細地倒入豎立的試筒中。
3、用手掌反復敲打試筒的下部,以除去氣泡,并使試樣盡快潤濕,然后放置10min mso-hansi-font-family:"Times New Roman"">。
4、在試筒上塞上塞子,將試筒水平放置,進行振蕩(僅用腕振蕩,不必晃動手臂)維持振幅230 mso-hansi-font-family:"Times New Roman"">±25mm "Times New Roman"">。振蕩90次,然后將筒豎直放在砂當量試驗儀, mso-hansi-font-family:"Times New Roman"">電動砂當量?jī)x試驗臺上,擰下塞子。
5、將沖洗管插入試筒內,用沖洗液沖洗附在試筒壁上的集料。然后逐漸將沖洗管插到試筒底部,慢慢轉動沖洗管,同時勻速緩慢提高沖選管,使附著在集料表面的土粒雜質浮游上來,直到溶液達到380ml mso-hansi-font-family:"Times New Roman"">刻度線。
6、當沖洗管抽出液面位于380ml mso-hansi-font-family:"Times New Roman"">刻度時,切斷沖洗管,然后開動秒表,在沒有擾動的情況下,靜置20min mso-hansi-font-family:"Times New Roman"">±15s "Times New Roman"">。
7、用尺量測從試筒底部到沉淀部分的高度h1 mso-hansi-font-family:"Times New Roman"">,如有可能同樣測得試筒底部到沉淀部分的高度,準確到lmm mso-hansi-font-family:"Times New Roman"">。
8、將配重活塞徐徐插入試筒里。直至碰到沉淀物時,擰緊套筒螺絲,將尺子的零點對準活塞的底面,從套筒上讀取沉淀物高度h2 mso-hansi-font-family:"Times New Roman"">,準確至lmm "Times New Roman"">。并記錄試筒內的濕度,準確到1 "Times New Roman"">℃。
9、按上述步驟進行兩個試樣的平行試驗。
mso-hansi-font-family:"Times New Roman"">五、電動砂當量測定儀注意事項:
1、試驗完畢后,須將活塞擦洗干凈。
2、避免圓形試筒磕碰。
3、定期向振蕩器滑動桿上注潤滑油。